Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit
is secure and able to support a weight of 10 times of the unit's weight.
IR REMOTE CONTROLLER
Please operate the remote control within a distance of 6m and 30° between the remote and the appliance. Aim
the remote at the sensor. Remove all obstacles between the remote and the sensor.
The remote control might not work properly if the sensor is exposed to strong sunshine.
If the remote control doesn't work properly, please check the batteries.
INSTALLING THE BATTERIES IN THE REMOTE CONTROL
•
Place the remote face down on a flat surface.
•
Push the compartment cover into the direction of the arrow.
•
Slide the battery compartment open.
•
Remove the old battery and install the new one (23A 12V) with the correct polarity.
•
Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in accordance with
your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
REMOTE CONTROL
ON/OFF: Light ON/OFF
LED: LED Auto running
LASER: Laser Auto running
A1: Red LED
A2: Green LED
A3: Blue LED
FLASH: Led+laser+LED strobe running
MUSIC1: Sound mode 1 LED effect
MUSIC2: Sound mode 2 Laser effect
MUSIC3: Sound mode 3 Strobe+LED+Laser effect
PAUSE: Effect pause
IMPORTANT NOTE : APPLIANCES CONTAINING LITHIUM-ION BATTERIES
1. PRIOR to using the unit for the first time, please charge fully the battery
2. Charge the battery regularly after each use. Don't wait until it is discharged!
3. DON'T allow the battery to discharge completely, otherwise it will lose 20% of its capacity or even be totally
damaged! If the voltage becomes too low, the internal circuits are not powered anymore and it will become im-
possible to recharge the battery!
4. If you don't use the unit for a longer period of time, it is recommended to charge it at 40% of its capacity and
check/charge it once per month.
The life time of the battery depends on the observance of these recommendations.
We cannot be held responsible for damaged batteries further to the non-observance of these basic
SPECIFICATIONS
Input voltage .......................................................................................................................................5Vdc 1A
Code: 16-1000
** BATTERIES ARE NOT COVERED BY THE WARRANTY **
www.ibiza-light.com
rules.
LED
LASER
ON/OFF
A1
A2
A3
FLASH
MUSIC
2
MUSIC
MUSIC
1
3
PAUSE
3
Publicidad
