Emos P5611OTR Manual De Instrucciones página 6

Deleting the Memory (Code) of Paired Units
To delete the pairing code used between the control and switching unit, follow the
instructions below. Press and hold the "ID" button on the switching unit; the red LED
will start flashing. Short press the "ID" button again within 10 seconds. The red LED
will stop flashing and goes out. The pairing code is deleted.
Mounting the Switching Unit onto the Wall
1. Remove the rear cover of the switching unit.
2. Mark positions for holes.
3. Drill two holes, carefully insert the plastic wall plugs into them and use two screws
to mount the rear cover of the switching unit.
4. Connect the wires to the labelled terminals according to the wiring diagram.
5. Complete the installation by fitting the switching unit onto the mounted rear cover.
Wiring Diagram
The P5611OT thermostat can be used with any one-stage heating or air-conditioning
system.
NO – switched contact
COM – contact for the switch
N/O
COM
ON
Pump/Motorised Valve Wiring Diagram
NO
Pump/valve
L N
230 V~
50–60 Hz
16 (5) A
COM L
L – 230 V AC power connection
N – neutral conductor
N
N
L
6