Publicidad
Idiomas disponibles
Idiomas disponibles
Do not operate below minimum liquid level marking. Low liquid level may result in motor failure,
creating a potential fire hazard. Fill tank to recommended operating capacity range before plugging
in power cord Do not operate with tank empty.
Operator shall wear appropriate PPE (personal protective equipment). Refer to cleaning fluid SDS
(safety data sheet) for details. If any cleaning solutions are splashed on clothing, remove wet
clothing promptly and thoroughly wash body areas that have been in contact with the solution. Do
NOT permit saturated clothing to remain in contact with skin. Cleaning solutions may irritate skin
and eyes. If splashed in eyes, flush thoroughly with water. Consult Safety Data Sheet (SDS) and a
physician. Always wear appropriate safety items such as gloves, apron, safety glasses or goggles.
Floor may be slippery when wet, do not splash fluids out of tank.
Use only recommended Zep Parts Washer Solvents. The use of aqueous based (water) cleaning
fluids will damage the finish and cause rusting. Non-approved products may be hazardous to the
operator and may damage the equipment, voiding the warranty.
Parts should be drained for at least 15 seconds or until dripping stops, whichever is longer.
Install unit on level surface. Do not overload tank floor, shelf, or trays. Load items evenly, do not
allow items to overhang outside tank. Refer to the user manual for weight load capacity
specifications.
795-93884
4 of 36
3/4/2022
Publicidad
