Max 43920 Manual De Instrucciones página 26

Disconnect the charger from the mains once
the battery is charged and insert it into the
drill.
Make sure the release button engages so
that the battery is � rmly in place.
NB! The battery is not fully charged on
delivery. It must be charged for about 3
hours prior to use. After that, charging takes
1 hour. The battery cannot reach full capacity
until it has been charged and discharged
around 5 times.
Preparation
Changing bits
Switch the direction selector (3) to its centre
position.
Turn the chuck (1) by hand to open the jaws
of the chuck. Insert the required drill bit into
the chuck and retighten.
Check that the bit is in the centre of the
chuck and is secure.
26
Selecting direction
Select direction (left or right) using the
switch (3).
If the switch is placed in the centre position,
the on/off button cannot be pressed in and
the drill cannot be started.
Selecting torque
Select the torque by turning the torque
selector (2) to the required position. The
higher the setting, the higher the torque
applied. To drill, turn the torque selector to
the position with the drill symbol.
Use
Fit a suitable drill or bit for the task. Select
gear, direction and torque.
Start the drill by pressing the on/off button
(7). The more the button is depressed, the
faster the chuck will revolve. The LED work
light (8) comes on and lights up the working
area when you press the on/off button.
Allow the drill to reach full speed before
starting to drill.
Do not press the drill too hard. Select a low
speed for screwing, large drill bits or hard
materials and a higher speed for small drill
bits or softer materials.
Switch off by releasing the on/off button.