JOCCA 6642 Manual De Instrucciones página 6

EN English
HOW TO THREAD THE TOP THREAD
-Lift up the presser foot lever and lift the needle by turning the balance wheel
following the arrow indicated on the same.
Follow the following instructions:
1.- Lift the bobbin pin and put
it in place(n).
2. Pull the thread through
guide 3 (o).
3.- Lead the thread through the
tension disc (q).
4.- Pull the thread through
guide 4 (s).
5.- Lead the thread through the
hole in the bar to tighten (r).
6.- Lead the thread through
guides 1 (a) and 2(c).
7.- Lead the thread through the
eye of the needle (d) from front
to back.
Scan the code
for watch the video:
PUTTING THE LOWER BOBBIN IN PLACE
• Remove the lid (F).
• Place the lower bobbin under this cover. There will be a
hole to place the bobbin and it should fit perfectly.
• Start lowering the needle using the needle control
wheel (M) in the direction indicated by the arrow (anti-
clockwise).
• Once the needle completes a cycle (lowering and
raising), the thread from the lower bobbin will have been
taken ( you can stretch the thread of the upper bobbin to
help, if not, return to perform a complete cycle).
• Once you have the two threads out, stretch them to
6