JOCCA 6642 Manual De Instrucciones página 7

English
EN
reach a length of about 10 cm and you can start sewing.
Cover the bobbin with its cover (F).
HOW TO START SEWING
1.- Lift the needle by turning the balance wheel clockwise. Lift up the presser
foot.
2.- Make sure that the two ends of the thread are placed needle backwards at
least 10 cm.
3.- Put the garment in place, hold it down with the presser foot and lower the
needle manually.
4.- Press the pedal or press the O/I button until I position and start sewing.
Slide the garment with your hand. Do it slowly for the first few stitches. If, while
sewing, by using either the pedal or through the On button, you need to modify
the sewing speed, press the speed control button: I position, normal speed and
II position, faster speed.
5.- To stop sewing, either stop pressing the pedal or place the on button in O
position.
IMPORTANT:
When finishing, lift up the needle manually, and in this way it will not bend when
taking the garment out; lift up the presser foot and withdraw the garment. Then
cut both threads at 10 cm. in length.
HOW TO ADJUST THE THREAD TENSION
-Revise if the lower thread and the top one have the same tension and if this
tension is strong enough to close both threads in the centre.
-If the top thread is too tight, the bobbin thread will be in the top part of the
garment. For this, slacken the needle thread.
WINDING THE LOWER BOBBIN
1.- Slide back the lid and extract the empty bobbin.
2.- Adjust the rewinding spindle in the hole for the winding of the bobbin (l). Turn
counter-clockwise.
3.- Lift up the foldable spindle (p) and insert a thread bobbin.
4.- Insert the thread through the small bobbin hole from theinside and take out
about 8 cm of thread.
5.- Hold the end of the thread tight and press the ON button orthe control pedal.
Stop once it has gone around a few times.
6.- Cut the end of the thread with scissors in the top part of the
bobbin and then continue with the winding until the amount ofthread desired
is wound.
7.- Cut the thread at about 8 cm from the bobbin. Extract thethread bobbin from
the spindle.
8.- Put away the spindle rewinder and put the long spindle in its place.
7