Publicidad
Preparation
Battery use
• Longer life and better performance can be obtained if the
battery unit is charged in room temperature between 5ºC and
45ºC Allow a hot battery pack to cool before charging.
• The charger and battery unit may heat up slightly during the
charging process. This is normal and does not represent any
problem. To make it easier to cool the battery unit after use,
avoid placing the charger or battery unit in a warm place, such
as a metal shed or trailer without thermal insulation.
Belt Clip Assembly
• Remove the screw (A) that is fixed to the base of the tool.
• Place the belt clip on either side of the tool using only the
provided screw (A), for adapting to right- or left-handed users.
• If you do not want to use the belt clip, you can remove it
from the tool.
• To move the belt hook, remove the screw (A) that holds it in
place and then reassemble it on the opposite side. Be sure to
firmly adjust the screw.
Tool/battery protection system
CAUTION
• The tool is equipped with a system that automatically stops the tool to prolong both its useful life and that
of the batteries, this happens in the following cases:
Overload. When the tool is forced, the battery consumes abnormally high current levels. Suspend overexertion work and turn
the tool back on.
Overheating. Let the tool and battery cool before turning it back on.
Over-discharge. The battery level is low. In this case, remove the battery from the tool and charge it.
Batteries
• To install the battery in the tool handle, align the battery unit with the rails on the inside of the tool handle and slide it into
the handle until the battery unit is firmly inserted into the tool; check that ir does not come off by itself.
• To remove the battery from de tool, press the release button (B) and firmly pull the battery out of the tool handle.
• To make sure the battery is charged, press the indicator button (C). The color of the light indicates the charge level.
• To make sure the battery is charged, press the indicator button on the battery (C) (For batteries that include it); or mount
the battery in the tool and press the switch (D) to check the battery level indicator on the tool (E).
B
Remaining battery capacity
Battery indicator
Indicator
lamp
Illuminated
OFF
NOTE: Depending on the conditions of use and ambient temperature, the indication may differ slightly from the actual capacity.
(Indicator on the tool)
Tool indicator
61% a 100%
Indicator
31% a 60%
Illuminated
0% a 30%
• The battery unit should be recharged when it is not able to
produce enough power for jobs that were easily performed
before. DO NOT CONTINUE to use it under these
circumstances. Follow the charging procedure.
• The best storage place is one that is cool and dry, away from
direct sunlight and excess heat or cold.
• For optimal results during extended storage times, it is
recommended to store the fully charged battery unit in a cool,
dry place outside the charger.
A
C
lamp
OFF
A
E
D
Green
61% to 100%
Orange
Red
31% to 60%
Orange
Red
0% to 30%
Red
ENGLISH
7
Publicidad
