Publicidad
Bits or adaptors assembly
• Using one hand, hold firmly the handle and with your
other hand loosen the base turning in a counterclockwise
direction.
• Insert the bit until it stops or remove it whichever the
situation.
• Turn the base clockwise to fasten the bit.
Direction of rotation
• To rotate forward release the trigger and press the direction button on the
side where marks point towards the chuck.
• To reverse the turn, press it on the other side.
• The hammer drill will get blocked if the button sits in the middle.
CAUTION
• The first time you turn on the hammer drill and after
reversing rotation you might hear a click. This in normal and does not
represent a problem.
• To prevent damaging the tool, never reverse the
CAUTION
rotation direction while the hammer drill is running.
Speed selection
• The two speeds in the drill work in a similar manner to those
used in cars.
• Low speed (1) will give a lot of torque (torsion power). Use this
speed when starting to drill large orifices, be it wood or metal. This
will prevent the bit to get stuck.
• High speed (2) has a reduced torque but lets the drill operate
with higher revolutions per minute, that make the tool when in
the drill function to bore faster lean metal or wood.
Change from hammer drill to drill
• To bore concrete, tiled floor or materials similarly hard, turn the torque
regulator into the IMPACT (
The bit will strike and rotate at the same time onto the material.
• To bore metal or plastic turn the impact-rotation selector chuck into the
CORDLESS HAMMER DRILL (
to make the bit rotate against the material.
WARNING
• Do not try to drill metal, wood or plastic with the
torque regulator in the IMPACT mode. Otherwise the tool efficiency
would diminish and the bit tip will get damaged.
Torque adjust to drill screw
• To select the desired torque level to screw drive, turn the
torque regulator until it matches the corresponding
number with the upper mark:
From 1 to 3 for small screws,
From 4 to 7 for screws on soft materials,
From 8 to 11 for screws on soft and hard material,
From 12 to 15 for screws on hard wood,
On 16 to 18, for larger screws.
8
ENGLISH
matching with the top mark) position.
matching with the top mark) position
Preparation
Forward
Torque
regulator
Torque
regulator
Chuck
base
Reverse
Publicidad
