Publicidad
Step 3
First, fi ll the holes in PANELS (B, C, D and E ) facing the
å
LEFT LEG (G), 1/4 to 1/2 full with GLUE (54M). Then,
insert four WOOD DOWELS (15F) into the holes. Wipe
away the excess GLUE.
Now, fi ll the 2nd, 5th, 8th, and 11th holes in the LEFT LEG (G)
å
1/4 to 1/2 full with GLUE. Then, insert the WOOD DOWELS
in the PANELS into these holes. Wipe away the excess
GLUE. Tighten eight HIDDEN CAMS.
Repeat this step gluing the WOOD DOWELS and RIGHT
å
LEG (F) to the other end of the PANELS (B, C, D, and E).
Then, tighten eight HIDDEN CAMS.
15F
These surfaces should
be nearly even.
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
www.sauder.com/services
1
ST
hole
G
nd
2
C
D
These surfaces should
be nearly even.
Start
Arrow
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely diffi cult.
Before you fasten the LEGS (G and F), be
sure the fi rst three holes in each LEG are
further apart and line up with the holes in
the LARGE PANEL (B).
Then, drop glue into the 2nd, 5th, 8th and
11th hole in each LEG (G and F).
B
E
Tighten
Maximum
210 degrees
Minimum
190 degrees
418388
Fill the holes 1/4 to
54M
1/2 full with GLUE.
IMPORTANT
1
ST
nd
2
F
15F
Arrow
hole
Page 7
Publicidad
