Publicidad
Idiomas disponibles
Idiomas disponibles
and that the water level is between the minimum and maximum levels
specified.
CAUTION! If the water level in the tank is too high, the pressure gauge
values may not be accurate. The water will automatically flow out
through the overflow pipe.
WATER CIRCULATION FUNCTION
To start the cold water circulation function, you must:
1.
outlet of the laboratory device needing cooling.
2. Set the ON/OFF switch to the ON position. The ON/OFF switch will illuminate.
3. Set the water circulation switch to the ON position.
4. When finished, turn the ON/OFF switch to the OFF position. All the lights will
go out. Pour the water out of the tank and drain it.
3.4. Cleaning and maintenance
a)
Cleaning
Pull the mains plug and let the device cool down completely before cleaning,
adjusting or replacing accessories and when the device is not in use.
Wait until the rotating parts stop.
•
b)
Pull out the mains plug before each cleaning and when the device is not in use.
c)
Use only non-corrosive cleaning agents for cleaning the surfaces.
d)
After each cleaning, all the parts should be dried well before the device is used
again.
e)
Store the device in a dry and cool place protected from moisture and direct
sunlight.
f)
Do not spray the device with a stream of water or immerse it in water.
g)
Make sure that no water enters through the ventilation openings in the casing.
h)
Clean the ventilation openings with a brush and compressed air.
i)
Perform regular inspections of the device checking technical fitness and any
damages.
j)
Use a soft, damp cloth for cleaning.
k)
Do not clean the device with acidic substances, medical products, diluent, fuel,
oil or other chemicals as this may cause damage to the device.
DISPOSAL OF USED UNITS.
Connect the water inlet and outlet of the device with the inlet and
and
maintenance
Publicidad
