Publicidad
Idiomas disponibles
Idiomas disponibles
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions or packaging. The materials used in this device are
recyclable according to their marking. You will be making an important
contribution to protecting our environment by reusing, recycling or otherwise
disposing of used devices.
Your local administration will provide you with information about the
appropriate disposal point for used devices.
TROUBLESHOOTING
Problem
No vacuum or
inaccurate gauge
reading
The motor does not
work
Warm motor, too
much noise
Water tank
Leakage
Possible cause
Motor speed is not
sufficient or the voltage is
too low
Clogged water inlet, filters
Rotor failure
Protective pipe is burnt
through
The bearing is broken
Motor winding burnt
Bearing worn out
Wear, deformation of the
rotor
Voltage instability or voltage
is too low
Water level is too low
Pass-through water nozzle
in the water tank is loose
Old seal
Water tank cracked
Action
Check that the voltage is
stable
Remove accumulated dirt
inside.
Clean the device
thoroughly.
Replace the impeller
Replace the protective tube
Replace the bearing
Replace the device with a
new one
Replace the bearing
Replace the impeller
Check if the line is
overloaded and if low
voltage occurs
Replenish water in the tank
Tighten the pass-through
water nozzle
Replace the sealing ring
Replace the water tank
Publicidad
