Publicidad
Idiomas disponibles
Idiomas disponibles
EN
ASSEMBLY
Step 1:
Attach the seat by means of 4-screw screws (Part 9) to the seat holder as shown below.
The thicker end of the seat should point to the rear end of the rowing machine.
Step 2:
Attach the left (10b) and the right (10a) connecting rod to the main tube (Part 1) and screw
these connecting rods (Part 10a& 10b) then by means of two six-edged screws (Part 11),
each two washers (Part 12) and each two safety nuts (Part 13) as shown below.
13
Publicidad
