Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Step 5:
Attach the fixing screw (part 27) with the help of the H-clamp (part 26) and a disc (part 12)
to the right rudder arm (19a) and tighten the screw. Repeat this working step for the rudder
arm on the other side (19b). Imagine r that the two H-clamps are on the rowing arms at the
same height. You can tell by the numbers on the rowing frames.
Attach the free end of the hydraulic cylinder (Part 25) by means of a support (Part 22) of a
washer (Part 12) and a safety nut (Part 13) at the bottom end of the H-clamp attached to
the rudder arm (26). The bolt should be inserted in such a way that it points from the
outside of the rowing machine inwards. Repeat this working step for the rowing arm on the
other side.
Step 6:
Drag the computer cable through the hole on the top of the main frame ( 1) and connect it
to the sensor cable ( 28) as shown. Push the computer into the corresponding bracket on
the top of the main frame.
15
Publicidad
