Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The appliance is not working at all.
The temperature inside the
compartment is not low enough.
The normal operating sound
changes or becomes louder.
Water is collecting on the bottom
of the unit.
Transporting the appliance
To prevent damage to the unit during transport, ensure that
all accessories and components inside and around the
appliance are securely fastened.
The unit must only be transported in its vertical position; do
not tilt any more than 30°.
Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
If the unit has been tilted more than 30° during transport,
allow it to stand in an upright position for at least 4 hours
before it is connected to the mains.
Disposal
Appliances that are marked with this symbol have
to be disposed of separately from household
rubbish. These appliances contain valuable
resources that can be recycled. A correct waste
disposal protects the environment and the health of those
around you. To get informed about it, either defer to your
municipal administration or the retailer.
∙ Pull the mains plug out of the socket and disconnect it
from the appliance before getting rid of it.
∙
The cooling medium Isobutane (R600a) and
the propellant in the isolation Cyclopentane
(C
H
) are inflammable substances, thus,
5
10
need to be appropriately disposed of.
∙ Make sure the tubes of the cooling circuit don't get
damaged before the proper disposal.
Possible cause and solution
∙ There is a power failure
∙ The main fuse has blown.
∙ The temperature control is set to '0'.
∙ The fuse in the wall socket (if applicable) has blown. This can be checked by
connecting another electrical device to the socket and checking for function.
∙ The cabinet has been overloaded.
∙ The doors are not properly closed.
∙ There is too much dust on the condenser.
∙ Insufficient ventilation: the unit is too close to a wall or other structure or object.
∙ The temperature setting is too low
Check the following:
∙ Check for proper positioning (uneven floor).
∙ Are any adjacent objects affected by the running of the cooling unit (i.e. causing
them to vibrate?)
∙ Are there any objects on top of the unit which might be vibrating?
The melt-water drain system is blocked. Remove the blockage and clean the
system.
Information needed by the Customer Service
Should repairs to the appliance become necessary, please
contact our Customer Service, providing a detailed fault
description and quoting the article number KS ... on the
rating plate of the appliance. This information will help us to
handle your request efficiently.
In case of any malfunction or other problem, or
for ordering replacement parts, please contact our
Customer Services Department hotline.
13
Publicidad
