Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
For stability, it is recommended you attach the unit to the wall. For instructions on how to attach the
unit directly to the mounting surface, refer to step 12. For instructions on how to attach the tipping
restraint hardware (LL), refer to step 13.
Step 12:
Adjust floor levelers to level the unit against the wall
where desired. Using back panel (G) as a template,
mark two mounting holes location on the wall. Drill two
pilot holes into the wall where previously marked. Make
sure that the drilled holes can fit for the wall anchors (sold
separately) properly. Press the anchors into the holes
and gently tap with a hammer until flush in the holes. If
the mounting hole coincides with a wooden stud, there
is no need wall anchor. Align back panel (G) and back
crossers (O) over the anchors and secure with two M5
x 65 mm screws (MM). Tighten securely with Phillips
screwdriver.
Hardware Used
MM
M5 x 65 mm
Screw
Step 13:
i. Locate and mark wooden studs where the unit is to be
installed.
ii. Drill a 1/8" pilot hole on the wooden stud approximately
3" below the height of unit top.
iii. Attach one bracket (a) securely with screw (c) into the
pilot hole on the wall.
iv. Attach the other bracket (a) with screw (d) to the back
edge of unit top in line with the bracket (a) on the wall.
v. Adjust floor levelers to level the unit against the wall
where desired.
vi. Put the male end of the steel cable (b) through each
bracket (a). Securely connect both ends together by
turning the female connector clockwise.
Hardware Used
LL
Tipping restraint hardware
v
12
Masonry/drywall
anchor not included
O
Wall
G
x 2
v
1 3
Wall
b
a
x 1
7
ASSEMBLY INSTRUCTIONS
Step 14:
Take barn door (N) and hang the top rollers (OO)
onto the hanging bar pre-attached on front upper
stretcher (F) while fitting the bottom groove onto the
installed L-bracket (DD). Insert one M4 x 15 mm bolt
(KK) into each barn door roller bracket to hold the
barn door (N) into place.
Hardware Used
KK
M4 x 15 mm Bolt
MM
CARE AND MAINTENANCE
b
•
Periodically check to make certain all components are properly positioned, free from damage
and firmly connected.
•
Use a soft, clean cloth that will not scratch the surface when dusting.
d
a
•
Never use water to clean the furniture as it may cause damage to the finish.
•
Wipe clean using a damp cloth and a mild cleaner. Wipe dry with a clean cloth.
•
In the event that the furniture is stained or otherwise damaged during use, it is recommended
c
you call a professional to repair the furniture.
•
Keep furniture away from direct sunlight as it may damage the finish.
•
It is best to keep the furniture in a climate-controlled environment. Extreme temperature and
humidity changes can cause fading, warping, shrinking and splitting of wood.
•
Touch-up pen (NN) has been provided to minimize the small nicks or scratches that may occur
during assembly or shipping.
v
14
KK
OO
DD
x 2
8
F
N
Publicidad
