Denon AVR-X1200W Manual Del Usuario página 32

Contents Connections
Speaker connection
Here we connect the speakers in the room to this unit.
This section explains how to connect them using typical examples.
NOTE
0 Disconnect this unit's power plug from the power outlet before connecting the
speakers. Also, turn off the subwoofer.
0 Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and - sides touch each other. ("Protection circuit" (v p. 258))
0 Never touch the speaker terminals while the power cord is connected. Doing so
could result in electric shock. When the "Setup Assistant" (page 8 in the separate
"Quick Start Guide") is running, follow the instructions in the "Setup Assistant"
screen for making connections. (Power is not supplied to the speaker terminals
while the "Setup Assistant" is running.)
0 Use speakers with an impedance of 4 – 16 Ω/ohms.
Front panel Display
Playback Settings
NOTE
0 Carry out the following settings when using a speaker with an impedance of 4 – 6
Ω/ohms.
1.
Press and hold the main unit's ZONE2 SOURCE and STATUS at the same
time for at least 3 seconds.
"V.Format:< NTSC>" appears on the display.
2.
Press DIMMER on the main unit twice.
"Sp.Imp.:<8ohms>" appears on the display.
3.
Press TUNER PRESET CH + or TUNER PRESET CH － on the main unit to
select the impedance.
6ohms:
4ohms:
4.
Press the main unit's STATUS to complete the setting.
32
Rear panel
Tips
Select when the impedance for any of the connected speakers is
6 Ω/ohms.
Select when the impedance for any of the connected speakers is
4 Ω/ohms.
Remote Index
Appendix