Publicidad
Idiomas disponibles
Idiomas disponibles
6. If it is very hard to pedal on the higher tension levels, or you hear rubbing noises, please
remove the Belt Cover (No. 66L/R), and adjust the screw seen in the following diagram. You
will need to lower the position of the screw by turning counter-clockwise; this will keep the
Magnetic Board (No. 89) from contacting the magnetic flywheel. Before re-installing the Belt
Cover (No. 66L/R), test the tension level 8 to ensure the magnets do not touch the flywheel.
。
7. If you still hear noises after you did Step 5 and Step 6, please remove the Belt Cover (No.
66L/R); loosen the screws for the Flywheel (No. 96) about a half of a rotation. See the
following diagram.
8. If you feel the machine is uneven, please adjust the Rear End Cap (No. 15) on Real Stabilizer
(No. 4) by turning it. If the machine is wobbly when you use it, please consider adding an
exercise mat under it.
14
Publicidad
