Publicidad
Idiomas disponibles
Idiomas disponibles
EN
9.1.1
INSTALL THE BATTERY PACK
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1.
Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2.
Push the battery pack into the battery
compartment until the battery pack locks into
place.
3.
When you hear a click, the battery pack is
installed.
9.1.2
REMOVE THE BATTERY PACK
1.
Push and hold the battery release button.
2.
Remove the battery pack from the machine.
10
OPERATION
• Do not put your fingers into the notches or in
position where they can get cut.
• Do not touch the blade unless you removed the
battery pack.
• Do not use the machine if the blade is damaged or
bent.
• Remove all objects such as cords, lights, wire, or
string from the cutting area which can become
entangled in the cutting blade and create a risk of
personal injury.
WARNING
English
If the blade jams on an electrical cord or line,
DO NOT TOUCH THE BLADE! IT CAN BE LIFE
THREATENING AND DANGEROUS. Follow the
steps below:
1.
Hold the insulated rear handle or put the
machine down and away from you.
2.
Disconnect the electrical service to the
damaged line or cord before you try to free the
blade.
10.1
START THE MACHINE
6
1.
Push and hold the micro switch with one hand.
2.
Push the trigger .
Hold the machine with hands during operation.
If the machine accidentally falls, it will stop and
the blade will fully stop after a few seconds. The
machine will then locks OFF.
10.2
STOP THE MACHINE
1.
Release the trigger to stop the machine.
10.3
TURN THE REAR HANDLE
8
WARNING
3
WARNING
NOTE
Publicidad
