Publicidad
Idiomas disponibles
Idiomas disponibles
You can use the rotating button to adjust the rear
handle to different positions to cut the hedges easier.
1.
Pull the rotating button and turn the rear handle.
2.
Release the rotating button until it locks into
position.
11
MAINTENANCE
CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the
plastic housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
11.1
CLEAN THE MACHINE
WARNING
Keep the machine and the motor free of leaves,
branches or excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
11.2
LUBRICATE THE BLADE
To increase the efficiency and life of the blades,
lubricate them carefully after each work session:
• Do not oil the blade while the hedge trimmer is
running.
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to
remove more dirt.
• Use a light layer of oil to lubricate the blades along
the top edge of the blade.
We recommend to use the non-pollutant type oil.
12
STORE THE MACHINE
Clean the machine before storage.
English
NOTE
NOTE
1.
Remove the battery pack.
2.
Let the motor cool.
3.
Check that there are no loose or damaged
components. If it is necessary, replace the
damaged components, tighten screws and bolts,
or speak to a person of an approved service
center.
4.
Store the machine in a cool and dry location.
13
TROUBLESHOOTING
Problem
Possible cause Solution
The battery
pack is not in-
The motor does
stalled tightly.
not start when
you pull the trig-
ger.
The battery
pack is out of
power.
The machine
The machine
smokes during
has damage.
operation.
The machine
has damage.
The motor is on,
blades do not
move.
The blades are
blocked.
Loose parts.
There is too
much noise
and/or vibration
during opera-
tion.
Damaged parts.
9
EN
Make sure that
you tightly in-
stall the battery
pack in the ma-
chine.
Charge the bat-
tery pack.
1.
Immedi-
ately stop
the ma-
chine.
2.
Remove
the battery
pack.
3.
Speak to
service
center.
Do not use the
machine and
speak to service
center.
Remove battery
pack then clear
blockage from
the blades.
1.
Stop the
machine.
2.
Remove
the battery.
3.
Inspect for
damage.
4.
Check and
tighten
loose
parts.
Do not use the
machine and
speak to service
center.
Publicidad
