Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL ASSEMBLY INSTRUCTIONS
4. Remove one of the two preassembled
shoulder screws in the hanger bracket (B).
Loosen the second shoulder screw without
fully removing it. Rotate ceiling canopy (D) so
second shoulder screw moves into the small
opening of the keyslot. Tighten shoulder
screw. Re-install the previously removed
shoulder screw to fully assembly ceiling
canopy (D) to hanger bracket (B).
WARNING
To avoid possible fire or shock, make sure the
electrical wires are completely inside the canopy
housing and not pinched between the housing
and the ceiling.
5. Securely attach and tighten the canopy
screw cover (E) over the shoulder screws in
the hanger bracket (B), utilizing the keyslot
twist-lock feature.
6. Securely attach the 9-pin connector from the
motor assembly (A) to the wire harness socket
within the light plate assembly (H).
WARNING
The color label on these two connectors must
correspond to each other.
4
5
6
H
12
Lowes.com/allenandroth
D
E
A
Publicidad
