Clutch Operation - Bulldog DC Serie Manual De Instrucciones

2.5 for first Time operation
2.5.1 Handheld Pendant Control
Industrial grade and waterproof remote. DC2500,
DC3500 and DC4500 winches includes LED
overheating indicator.
2.5.2 Connect the remote control
Always keep the remote control wire clear of the
winch, wire rope and roller fairlead. Figure 14.
WARNING
DO NOT leave the pendant control plugged
into the winch when not in use. This may result
in a dangerous condition and/or battery drain.
1. Press and hold the Cable In Button for rope
winding in operation.
2. Press and hold the Cable Out Button for rope
winding out operation.
3. To stop winching, release the Cable In or Cable
Out Buttons. Figure 15.

2.6 Clutch Operation

WARNING
NEVER engage or disengage clutch if winch is under load, winch rope is in tension or drum is
moving.
To prevent damage, ALWAYS fully engage or fully disengage the clutch lever.
The clutch lever allows rapid wire rope payout
for hooking onto the load or anchor points and is
operated by a clutch lever.
The clutch lever must be in the
"Engaged" position before winching (fig 16)
1. To disengage the clutch lift the clutch lever to
the "Disengaged" position, wire rope can now
be free spooled on the drum (fig 17)
2. To engage the clutch, lower the clutch lever to
the "Engaged" position
3. If the clutch lever can't be properly locked in
the "Disengaged" position, rotate the drum to
into a position by hand to Engage or Disengage
completely.
4. Wear leather gloves and use a handsaver strap
when guiding the wire rope out of the drum.
14
CEQUENT
Operation Instructions
PERFORMANCE PRODUCTS, INC. •
™
Figure 14 - Connect Remote
Figure 15 - Cable Button
Cable-Out
Figure 16 - Engaged Clutch
Clutch
Lever
Figure 17 - Disengage Clutch
F3837-00 REV B (4782) 08/15
Cable-In
Engaged
To disengage,
lift the clutch lever