Clutch Operation - Bulldog DC Serie Manual De Instrucciones

2.4 For First Time operation
2.4.1 Handheld Pendant Control
Utility Grade Remote with 100" cord.
2.4.2 Connect the remote control
Always keep the remote control wire clear of the
winch, wire rope and roller fairlead.
WARNING
DO NOT leave the pendant control plugged
into the winch when not in use. This may result
in a dangerous condition and/or battery drain.
1. Press and hold the Cable In Button for rope
winding in operation.
2. Press and hold the Cable Out Button for rope
winding out operation.
3. To stop winching, release the Cable-In or
Cable -Out buttons on the handle bar remote.
Figure 7.

2.5 Clutch Operation

WARNING
NEVER engage or disengage clutch if winch is under load, winch rope is in tension or drum is
moving.
To prevent damage, ALWAYS fully engage or fully disengage the clutch knob.
The clutch knob allows rapid wire rope payout for
hooking onto the load or anchor points.
The clutch knob must be in the
"Engaged" position before winching (Figure 8).
1. To disengage the clutch rotate the clutch knob
to the "Disengaged" position, wire rope can
now be free-spooled from the drum (Figure 9).
2. To engage the clutch, rotate the clutch knob to
the "Engaged" position.
3. If the clutch knob cannot be properly locked in
the "Disengaged" position, rotate the drum to
into a position by hand to Engage or Disengage
completely.
4. Wear leather gloves and use a handsaver strap
when guiding the wire rope in or out of the
drum.
Operation Instructions
HORIZON GLOBAL •
Figure 6 - Connect Remote
Figure 7 - Cable Button
Cable-Out
Figure 8 - Engaged Clutch
Clutch
Knob
Figure 9 - Disengage Clutch
F4106-00 REV A (9528) 11/17
Cable-In
Engaged
To disengage,
turn the clutch knob
11