Descargar Imprimir esta página

Flama 1221FL Manual De Instrucciones página 20

Cafetera express

Publicidad

Idiomas disponibles

Idiomas disponibles

Now the machine is ready for use.
NOTES: Above simple operation ensures
optimum dispensing and must be carried
out:
-When first starting
-When the machine has been out of use for
a long time (1-2 weeks).
-When the tank has run out of water.
Usage
IMPORTANT - Make sure that the water
tank has water.
Switch the ON/OFF button; the START
button blinks.
Turn the switch to the '0' position to start
preheating. The START button blinks a blue
light during preheating; it remains lit when
preheating is finished.
Note: when the machine finishes dispensing
coffee or steaming, it will dispense an
amount of water into the drip tray and turn
the switch to the '0' position. This is normal.
Coffee Mode
Select the desired filter (1 coffee or 2
coffees)
Place the filter in the filter holder.
Use the measure spoon to measure the
amount of ground coffee powder for the
desired filter. Press evenly the coffee
powder onto the filter with the flat end of
the measure spoon/presser.
Insert the filter holder into the machine.
Insert the filter holder into the machine
from left to right until it locks.
Place the cup on the grid below the coffee
spout.
Note: After dispensing the coffee, turn the
18
switch to the '0' position before removing
the filter holder.
Pre-infusion
Pre-infusion is the process of soaking, for a
few seconds, the ground coffee in a small
amount of water, before proceeding with
the total extraction of the coffee. The aim
is to ensure that the water passes evenly
throughout the ground coffee, resulting in
a more efficient extraction.
For 1 espresso:
Turn the switch to the coffee position.
Press the START button shortly. The blue
light of the START button starts blinking,
the machine starts the pre-infusion for a
few seconds, and then dispenses coffee.
Dispensing stops automatically, however
you can press the START button again to
stop dispensing once you reach the desired
amount of coffee. The blue START button
light turns on.
Turn the switch back to the '0' position
to enter standby mode, remove the filter
holder by turning from right to left, clean
the filter holder, and dry it after use.
For 2 espressos:
Turn the switch to the coffee position.
Press the START button for 3 seconds. The
START button starts blinking a purple light,
the machine starts the pre-infusion for a
few seconds, and then dispenses coffee.
Dispensing stops automatically, however
you can press the START button again to
stop dispensing once you reach the desired
amount of coffee. The blue START button
light turns on.
Turn the switch back to the '0' position
www.flama.pt

Publicidad

loading