EINHELL GE-LS 18 Li Manual De Instrucciones página 21

10. Troubleshooting guide
Danger!
Before troubleshooting, switch off the equipment and remove the battery.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem
if your equipment fails to work properly. If you fail to localize and solve the problem after working through
the list, please contact your nearest service workshop.
Fault
The equipment
does not work
The equipment
stops during cutting
The cutting blade
becomes jammed in
a thick branch
The cut is not
smooth
Anl_GE_LS_18_Li_SPK9.indb 21 Anl_GE_LS_18_Li_SPK9.indb 21
GB
Possible cause
- Set the ON-OFF main switch to the
OFF position
- Battery empty
- Battery is not correctly inserted
- Battery empty
- Battery capacity low
- Battery capacity low
- Holz zu hart
- Wood diameter too large
- Cutting blade is blunt or worn
- 21 -
Remedy
- Set the ON-OFF main switch to ON
- Charge battery
- Remove battery and insert again
(see section 5.2)
- Charge battery
- Charge battery
- Charge battery
- Wood is unsuitable for cutting
- Wood is unsuitable for cutting
- Replace cutting blade
13.04.2023 06:39:26 13.04.2023 06:39:26