Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Before Calling for Service
Please check the following before you contact the service center. If the problem persists, contact your local
service center.
Operation
Symptoms
The appliance does not
operate.
There is odor, but the
air quality light doesn't
change
The air quality light
stays red.
The buttons on the
control panel do not
work.
The PM concentration
doesn't change.
The PM concentration
stays high.
The color of the overall
air quality light does
not match the PM
concentration value.
The clean booster is
not working.
Possible Causes & Solution
The power plug in unplugged from the outlet.
• Plug it into the outlet properly.
Is the air quality light red or orange?
• The color of the overall air quality light is determined by the worst level
sensed, whether that is a PM concentration or odor. The PM concentration
level may be worse than the odor level.
• The odor (gas) sensor is designed to detect harmful gases. Strong food
odors may not register as harmful, but the Deodorizing Care filter will
minimize them.
Move the appliance to a different room and see if the color changes.
• If the odor level is beyond the capacity of the product to dispel, the light
may not change.
• Clean the sensor area.
• Remove the power plug from the outlet and reconnect it one minute later.
A substance was sprayed near the product.
• Do not use sprays near the product.
The k (Lock) is turned on on the status display panel.
• Press and hold the Sleep Timer button for 3 sec. To disable the lock
function.
There is a foreign substance on the sensor.
• Clean the PM1.0 sensor.
The product is used in an enclosed space.
• In an enclosed space without frequent air exchange, the air quality may
stay the same.
The product is located in an area with frequent airflow from the outside.
• In an environment where outside air is supplied continuously, the PM
concentration may remain high.
The overall air quality light may be reflecting the odor level.
• The overall air quality is based on both the PM concentration and the odor
level, and its color is determined by which is worse.
• If the PM concentration is low and the odor level is high, the overall air
quality light will reflect the odor level.
The Booster mode is not selected.
• The booster fan speed and booster fan rotation functions work only in the
Booster mode.
EN
29
Publicidad
