Whirlpool WM1807 Instrucciones Para El Usuario página 2

INSTALLATION
Installation
SAFETY
Important safety instructions
Trouble shooting guide
Precautions
ACCESSORIES AND MAINTENANCE
Accessories
Maintenance & Cleaning
Environmental Hints
CONTROL PANEL
Control panel & Display Description
GENERAL USE
Standby mode
Start Protection / Child Lock
Pause or Stop cooking
Add / Stir /Turn food
Clock
COOKING FUNCTIONS
Jet Start
Microwave
Defrost
Mute
Auto Cook Menu
Soften/Melt
Keep Warm
Auto Clean
ENVIRONMENTAL HINTS
Technical Specifications
2
INDEX
PRIOR TO CONNECTING
Position the microwave oven at a distance from
other heating sources. For sufficient ventilation,
3
there must be a space of at least 30 cm above the
microwave oven.
The microwave oven should not be placed in a
4
cabinet. This microwave oven is not intended to be
5
placed or used on a working surface lower than 850
6 mm above the floor.
* Check that the voltage on the rating plate corresponds to the voltage in your home.
* Place the microwave oven on a stable and even surface that is strong enough to hold
7
the microwave oven and the food utensils you put in it. Use carefully when handling.
8
* Ensure that the space underneath, above and around the
8
microwave oven is empty to allow for proper airflow.
* Ensure that the appliance is not damaged. Check that the microwave oven door is
closed firmly against the door support and the internal door seal is not damaged.
9
Empty the microwave oven and clean the interior with a soft, damp cloth.
* Do not operate this appliance if it has a damaged mains cord or plug,
if it is not working properly, or if it has been damaged or dropped. Do
10
not immerse the mains cord or plug in water. Keep the cord away from
10
hot surfaces. Electrical shock, fire or other hazards may result.
10
11
11
12
13
Electrical Shock Hazard
14
Disconnect power before servicing.
15
Replace all parts and panels before
16
operating.
20
Failure to do so can result in death, fire,
21
or electrical shock.
22
NOTE:
23
Prior to using the microwave for the first time, it is recommended to remove the
protective film from the control panel and the cable tie from the power cord.
INSTALLATION
30cm
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
3