Beamz Pro BBP44 Manual página 5

Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present,
and have been received in good condition. Notify the shipper immediately and retain packing materi al for inspection if any parts appear
damage from shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the eve nt that the product
must be returned to the factory, it is important that the product be retu rned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to
this, all other voltages than specified, the light effect can be irreparably damaged. The product must also be direct ly connected to the mains and
may be used. No dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground
to avoid the risk of electrocution or fire.
1. Press off existing modes.
2. Press again to return the last modes.
Automatic mode will enable you to run the automatic light programs. To turn on automatic mode:
1. Press on the remote controller. Display shows
2.Press again. Display shows
3. Press or to choose between the different auto programs.
4. Press again to turn off the auto mode.
Sound mode will enable the product to respond to the music. To turn on sound mode:
1. Press on the remote controller.
2. Press and then press
3. Press again to turn off the sound mode.
Activate the strobe function in automatic or sound mode .
1. Press on the remote controller.
2. Press or to either increase or decrease the speed of strobe.
3. Press again to turn off the strobe.
No function
To adjust sound sensitivity for in sound mode.
1. Press on the remote controller.
2. Press or to either increase or decrease sound sensitivity.
3. Press again to turn off the sensitivity mode.
No function
To adjust the fade speed of the automatic program, the sound active program and the manual mode.
1. Press on the remote controller. Display shows
2. Press or to either increase or decrease the speed of the program.
3. Press again to turn off the fade mode.
1. Select static colour with the buttons
2. Press or to either increase or decrease brightness.
.
.
or to increase or decrease the sound sensitivity.
.
or digit to .