Makita HXU01 Manual De Instrucciones página 7

Flipping the speed change switch lever to the "1"
position will set the tool to the low speed range and the
"2" position will set the tool to the high speed range.
Battery/motor protection system
The battery cartridge and tool are provided with
protection devices that will automatically reduce or cut
off power to the tool when overload situations develop
that may cause damage to the tool or battery cartridge.
If the tool becomes overloaded but not locked up a
protector is provided to reduce the revolutions to protect
the motor. In this case the two indicator lamps described
in the table below do not light or blink.
All other protection functions can be identified by the
indicator lamps described in the table below.
1
012967
- Blinking
- Lighting On
Blinking
Lighting On
Blinking Blinking
010823
1. Indicator lamps
Status
Battery power has been
nearly used up.
Battery protector is
shutting off the power -
battery power has been
used up.
Overload protector is shutting
- off the power - the motor was
locked.
Overheat protector is shutting
-
off the power - overheating.
Electric or electronic
malfunction
Action to be taken
Replace the battery with fully charged one.
Replace the battery with fully charged one.
Release the switch trigger and remove the
cause of the motor lock or overload. If the
cutting tool is locked by entangling weeds or
the like, always remove the battery cartridge
before clearing it.
Rest the equipment for a while.
Ask your local authorized service center for
repairs.
7