Increasing Or Reducing The Set Speed By 1 Km/H; Switching Off The Cruise Control Function; Restoring The Set Speed Stored Last - VDO Pedal Interface II Instrucciones De Funcionamiento

2.4 Increasing or Reducing the Desired Speed by 1 km/h (Tip-up /
Tip-down Function)
Briefly tip the selector switch toward the described position (see table,
page 24) and release. This procedure can be repeated as desired.

2.5 Switching Off the Cruise Control Function

Push the selector switch towards the described position (see table, page
24) and release, or:
• depress the brake pedal, or
• depress the clutch
2.6 Restoring the Last Stored Set Speed Stored Last after
Switching Off by Brake Pedal or Clutch (Memo Function)
Standard selector switch:
VDO Pedal Interface II stores the last set speed until this
function is switched off by switching off the ignition or ac-
tivating the variable variable road speed limit.
LED- and flexible selector switch:
VDO Pedal Interface II stores the last set speed until this
function is switched off by the selector switch (Off) or the
ignition is switched off.
Calling up: Push the selector switch briefly toward the described position
(see table, page 24) and release. VDO Pedal Interface II accelerates the
vehicle in a controlled manner to the speed stored last and maintains
this speed.
Risk of damage caused by the engine overspeeding!
Select "memo" only in the gear in which you were driving
with the previous set speed.
21