Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
INCLUDED PARTS - SLEEVE
1. Bottom panel
2. Top, left and right panel assembly
3. Rear grill
4. Seal A (26.4" long)
5. Seal B (1.6" long) x2
6. Insulation strips x2
7. Long screws x4
8. Short screws x14
1
2
3
INCLUDED PARTS - DRAIN KIT
1. Cover plate x1
1. Cover plate with drain outlet
2. Foam gasket x2
3. Bent tube x1
4. Screws ST3.9*14 (optional) x4/x6
Note: The drain kit is optional. If you plan to use the
drain kit, make sure to assemble and install it before
installing the air conditioner in the sleeve.
1
2
4
4
5
6
7
8
3
5
ASSEMBLY - SLEEVE
1. Open the left and right panels.
2. Secure with 6 short screws.
3. Use 8 short screws to secure the bottom panel.
4. Attach foam seal A and B.
5. Attach foam strips to the rear grill in the
positions shown.
6. Attach the rear grille to the sleeve by sliding
the holes in the rear grille over the protruding
screws on the sleeve as shown.
7. Once the holes in the rear grille clear the head
of the screws in the sleeve, pull down on the rear
grille so that the screws slide into the "U" holes
as shown.
8. The rear grille is properly installed when the
screws in the sleeve slide into the bottom of the
"U" holes on the rear grille.
9. Add two additional screws through the rear
grille into the sleeve as shown below.
1
2
3
4
A
6
B
5
1
6
7
8
9
B
Publicidad
