Publicidad
Idiomas disponibles
Idiomas disponibles
1�
Snooze / Sleep Button
2�
Time Button
3�
Min / Day Button
4�
Hour / Month Button
5�
MEM Button
6�
Dimmer Button
7�
Vol / ALM1 Button
8�
Vol / ALM2 Button
9�
Power / Source / ALM off
GETTING STARTED
BATTERY INSTALLATION
This clock uses 2 AAA batteries to back up the time and alarm settings in the
case of a power outage. These batteries are not for everyday operation. The
clock should stay plugged in when in use.
To install batteries, open the battery cover on the bottom of the clock.
Then, match the "
battery cover. If the clock is not used for an extended period of time,
remove the batteries before storing it.
SETTING THE TIME
Press and Hold MEM until the numbers blink.
1.
2.
Press the HOUR and MIN buttons to set the time.
Press MEM to confirm the time.
3.
Set the year using the HOUR/MONTH and MIN/DAY buttons.
4.
5.
Press MEM to confirm the year.
Set the Month and Day using the HOUR/MONTH and MIN/DAY buttons.
6.
Press MEM once more to confirm and exit.
7.
THE SOURCE BUTTON
The Source / ALM OFF button turns the clock radio on.
Press it mutiple times to cycle between 4 different modes:
OFF (Standby) > FM > AM > AUX. When the clock is in standby,
it will remain silent until an alarm sounds, or until the SOURCE
button is pressed to turn the clock on for FM, AM, or AUX mode.
(BATTERIES NOT INCLUDED)
+
–
" and "
" signs with the batteries. Replace the
–7–
10� LED Display
11� PM Indicator
12� Alarm indicators
13� Speaker
14� AUX IN Jack
15� FM Antenna
16� AC Power cord
17� Battery Door
Publicidad
