Publicidad
Idiomas disponibles
Idiomas disponibles
Infl ation
Infl ate the Spa Tub Wall
Take out the ground cloth (19) and spread it over the cleared area. Then spread out the spa liner over
1.
the ground cloth and point the drain valve towards a suitable draining area.
NOTE: Spread the ground cloth with the bubbles facing down over the cleared area where you intend
to setup your spa.
Flip up the control base side cover (4) to reveal the air blower infl ation outlet. Pull out the latch to open
2.
the cover, insert the hose adaptor (24) with hose and reattach the latch to the hose adaptor to secure it
in place (see drawing 2).
2
1
Unscrew the air valve cap on the spa tub to reveal the stem in the
3.
up position for infl ation. Insert the other end of the infl ation hose (7)
into the valve and turn to the right to lock it in position (see
drawing 3).
Press the
button to turn on the control panel buttons fi rst. Press
4.
the
button to infl ate the spa tub wall for 8 to 10 minutes until it
is fi rm to the touch but not hard (see drawings 4 & 5).
IMPORTANT: Do not over infl ate or use high pressure air
compressor to infl ate.
S AVE THESE INSTRUCTIONS
SET UP (continued)
4
3
5
(347PO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 07/11/2019
347
English
PO
2
3
1
2
7
4
Page 9
Publicidad
