Descargar Imprimir esta página

Royal Catering RCIC-50SF Manual De Instrucciones página 20

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 76
2.4.
Safe use of the device
a)
Do not overload the device. Use tools that are suitable for the application. A
correctly selected product will do a better and safer job for which it was
designed.
b)
Do not use the device if the ON/OFF switch does not function properly (does
not turn on and off). Units that cannot be controlled by the switch are unsafe,
cannot operate, and must be repaired.
c)
Disconnect the device from the power supply before adjusting, cleaning, or
servicing. This precaution reduces the risk of accidental start-up.
d)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
e)
To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
f)
When transporting or moving the device from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the device is used.
g)
Avoid situations in which the device stops under heavy loads during operation.
This can cause overheating of the drive elements and consequent damage to
the equipment.
h)
Do not touch any moving parts or accessories unless the device is unplugged.
i)
Do not move, shift, or rotate the device while in operation.
j)
Clean the device regularly to prevent permanent dirt build-up.
k)
The product is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
l)
Do not tamper with the device to alter its performance or design.
m) Keep the unit away from sources of fire and heat.
n)
Do not block the ventilation openings of the unit!
o)
Before the first use and after each transport, set the device in its intended
location and wait at least 12 hours before starting it.
p)
Running water is recommended for use.
q)
Do not put the unit upside down or tilt it at an angle of more than 45 °.
r)
Keep a free space around the unit (minimum 15 cm on each side).
s)
To avoid damaging the compressor, do not press the power button more often
than every 5 minutes.
t)
During operation, the vicinity of the compressor and the condenser may reach
a temperature of 70-90°C, do not touch these elements and do not place them
near flammable materials.
u)
Do not use mechanical devices to accelerate the cooling down process!
v)
Do not damage the refrigerant circuit.
w)
Do not use electrical appliances inside the refrigerator other than those
provided by the manufacturer.

Publicidad

loading

Este manual también es adecuado para:

Rcic-25sf