Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions for use Rotaplex Visign RT3 / RT5
GB
D
Pipe interrupter
Safeguard drinking water from contamination.
The drinking water quality must not be affected by bath water flowing back into the
drinking water system. To prevent contamination, a pipe interrupter must be installed
between the concealed shut-off fitting and the bathtub inlet. Local standards and regu-
lations must be observed.
Note: The pipe interrupter is not included in the scope of delivery and must be ordered
separately!
Backflow situation:
If an underpressure situ-
ation should occur when
the bathtub is filled,
there is a risk that water
from the tub will flow
back into the drinking
water system.
E
Assembly steps
Mount seal. With steel
bathtubs with wall thick-
ness d
max
both seals.
Insert double seal.
Bowden wire length
725mm:
Mount overflow pipe. If
necessary, shorten. The
overflow pipe must be
inserted at least 15 mm
into the connection.
Installation diagram
Push the inlet piece into
≤ 3 mm mount
Attach the stainless
Bowden wire length
the overflow unit.
steel flange to the drain
fitting using the fastening
screws.
1070 mm:
Mount overflow pipe. If
necessary, shorten. The
overflow pipe must be
inserted at least 15 mm
into the connection.
31
Connecting set with
concealed pipe inter-
rupter DN 20 in acc.
DIN EN 1717 DB
model 6161.86
Screw the fastening
screws in hand tight.
Caution: On the
hexagon of the fastening
aid (included in the
scope of delivery), there
is a groove, which must
be positioned on the lip
of the fastening screw.
Push the rubber sleeve
onto the overflow pipe
until the lower edge is
flush with the edge of
the overflow pipe.
Bowden wire length
725mm, 1070mm:
Push the top end of the
overflow pipe into the
sleeve.
Push the union nut,
sliding ring and wedge
seal onto the overflow
pipes and screw tight.
Publicidad
