Descargar Imprimir esta página

Viega Rotalex Trio Visign RT3 Serie Instrucciones De Uso página 32

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
Instructions for use Rotaplex Visign RT3 / RT5
GB
E
Assembly steps
 Bowden wire length
725mm:
The pipe must be
inserted at least 15 mm
into the sleeve and the
drain casing.
 Push sliding ring and
wedge seal onto the
drainage elbow. Screw
the drainage elbow onto
the odour trap using the
union nut.
p Align the odour trap and
connect to the waste-
water system.
F
Equipment set
 Turn rotatable collar to
the right (open position).
Hold rotatable collar
tight and insert valve
cone.
 Turn the rotatable collar
to the right, valve cone
open.
G
Removal of equipment set
 Remove rotatable collar
in axial direction.
H
Setting jet control
 Water jet setting at the
jet control.
 Bowden wire length
1070mm:
The pipes must be
inserted at least 15 mm
into the sleeve and the
drain casing.
 Connect the water
inlet to the connecting
adapter.
q Check the drain fitting
for leaks after assembly.
 Mount flange cover,
rotatable collar, valve
cone and cover plate.
 Pry out and remove the
flange cover at the inser-
tion point.
32
 Cut the drain elbow if
the wastewater pipe
should only have a
diameter of 40 mm.
 Insert the connecting
adapter with the
mounted water inlet all
the way into the over-
flow fitting until it makes
a clicking noise.
 Turn the rotatable collar
to the left, valve cone
closed.

Publicidad

loading