Publicidad
Idiomas disponibles
Idiomas disponibles
Select an installation site where the following conditions are satisfied and one that meets with your customer's
approval.
- Safe places which can bear the unit's weight and where the unit can be installed at an even level.
- Places where there is no possibility of flammable gas or product leak.
- The equipment is not intended for use in a potentially explosive atmosphere.
- Places where servicing space can be well ensured.
- Places where the units' piping and wiring lengths come within the allowable ranges.
- Places where water leaking from the unit cannot cause damage to the location (e.g. in case of a blocked drain
pipe).
- Do not install the unit in place s often used as a work space. In case of construction work (e.g. grinding etc.) where
a lot of dust is created, the unit must be covered.
- Do not place any object or equipment on top of the unit (top plate)
- Do not climb, sit or stand on top of the unit.
- Be sure that sufficient precautions are taken in case of refrig erant leakage according to relevant local laws and
regulations.
- Don't install the unit near the sea or where there is corrosion gas.
When installing the unit in a place exposed to strong wind, pay special attention to the following.
In normal condition, refer to the figures below for installation of the unit:
The indoor unit should be installed in an indoor water proof place.
The indoor unit is to be floor mounted in an indoor location that meets the following requirements:
The installation location is frost-free.
The space around the unit is adequate for serving (Refer to Fig.4-2).
There is a provision for condensate drain and pressure relief valve blow-off.
When the unit is running in the cooling mode, condensate may drop from the water inlet and water outlet
pipes. Please make sure the dropping condensate will not result in damage of your furniture and other
devices.
4 INSTALLATION
4.1 Dimensions of the unit:
CAUTION
CAUTION
2
1
Fig.4-1
2
1
11
V.2
Publicidad
