Publicidad
Idiomas disponibles
Idiomas disponibles
NO.
1
Refrigerant gas connection 5/8"-14UNF
2
Refrigerant liquid connection 3/8" -14 UNF
3
Domestic hot water outlet R3/4''
Domestic hot water recirculation
4
inlet (Plugged by the nut).
5
Domestic cold water inlet
The content in the dotted line area is for customized
.2 Installation requirements
4
The indoor unit is packed by the carton cap and corner.
At delivery, the unit must be checked and any damage must be reported immediately to the carrier claims agent.
Check if all indoor unit accessories are enclosed.
Bring the unit as close as possible to the final installation position in its original package in order to prevent
damage during transport.
When the water tank is free of water, the maximum net weight of indoor unit with water tank shall reach about
158Kg which needs to be lifted by special equipment.
4.3 Servicing space requirements
4.4 Mounting the indoor unit
Lift the indoor unit from the pallet and place it on the floor.
Slide the indoor unit into position.
Adjust the height of the leveling feet（Refer to Fig.4-3）to compensate for floor irregularities. The maximum
allowed deviation is 1º (Refer to Figure. 4-4)
Be specially careful with the mounting foot once the unit is on the floor. Avoid harsh handling of the unit, as it
could cause damages to the foot.
Each mounting feet can be adjusted up to 30mm, but keep all them in the factory supplied position unit has
been installed in the final position
NAME
NO.
≥600
Fig. 4-2
12
NAME
6
Space heating (cooling) water inlet .R1"
7
Space heating (cooling) water outlet .R1"
8
Drainage
25
9
Solar circulation outlet (customized)
10
Solar circulation inlet (customized)
≥100
unit: mm
≥100
≥800
Unit: mm
V.2
Publicidad
