Publicidad
Idiomas disponibles
Idiomas disponibles
In this case, the setting value of zone 1 is T1S, the
setting value of zone 2 is T1S2.
If you set DOUBLE ZONE and ROOM TEMP. to
YES, meanwhile set WATER FLOW TEMP. to YES
or NON,the following page will be displayed.
◄
Homepage (zone 1)
In this case, the setting value of zone 1 is T1S,the
setting value of zone 2 is T1S2 (The corresponding
TIS2 is calculated according to the climate related
curves.)
8.4.6 ROOM THERMOSTAT
About ROOM THERMOSTAT
The ROOM THERMOSTAT is used to set whether
the room thermostat is available.
How to set the ROOM THERMOSTAT
Go
to
MENU>
FOR
SERVICEMAN>
THERMOSTAT. Press OK. The following page will
be displayed:
6 ROOM THERMOSTAT
6.1 ROOM THERMOSTAT
ADJUST
NOTE
ROOM THERMOSTAT = NON, no room
thermostat.
ROOM THERMOSTAT = MODE SET, the wiring
of room thermostat should follow method A.
ROOM THERMOSTAT=ONE ZONE, the wiring
of room thermostat should follow method B.
ROOM THERMOSTAT=DOUBLE ZONE, the
wiring of room thermostat should follow
method C (refer to 7.6
other components/For room thermostat")
2
Addition page (zone 2)
(Double zone is effective)
6.ROOM
NON
"Connecting
for
32
8.4.7 OTHER HEATING SOURCE
The OTHER HEATING SOURCE is used to set the
parameters of the backup heater, additional
heating sources .
Go to MENU> FOR SERVICEMAN> 7.OTHER HEATING
SOURCE, Press OK. The following page will be
dispayed:
7 OTHER HEATING SOURCE
7.1 dT1_IBH_ON
7.2 t_IBH_DELAY
7.3 T4_IBH_ON
7.4 dT1_AHS_ON
7.5 t_AHS_DELAY
ADJUST
7 OTHER HEATING SOURCE
7.6 T4_AHS_ON
7.7 IBH LOCATE
7.8 P_IBH1
7.9 P_IBH2
7.10 P_TBH
ADJUST
8.4.8 HOLIDAY AWAY SETTING
The HOLIDAY AWAY SETTING is used to set the
outlet water temperature to prevent freezing
when away for holiday.
Go to MENU> FOR SERVICEMAN> 8.HOLIDAY
AWAY SETTING. Press OK. The following
page will be displayed:
8 HOLIDAY AWAY SETTING
8.1 T1S_H.A._H
8.2 T5S_H.A._DHW
ADJUST
8.4.9 SERVICE CALL SETTING
The installers can set the phone number of the
local dealer in SERVICE CALL SETTING. If the unit
doesn't work properly, call this number for help.
Go to MENU> FOR SERVICEMAN>SERVICE CALL.
Press OK. The following page will be displayed:
9 SERVICE CALL SETTING
PHONE NO. ******************
MOBILE NO. ******************
OK
CONFIRM
ADJUST
Press ▼ ▲ to scroll and set the phone number.
The maximum length of the phone number is 13
digits, if the length of phone number is short
than 12, please input ■, as shown below:
1/2
5°C
30MIN
-5°C
5°C
30MIN
2/2
-5°C
PIPE LOOP
0.0kW
0.0kW
2.0kW
20°C
20°C
V.2
Publicidad
