Publicidad
Idiomas disponibles
Idiomas disponibles
The charger has 2 LED indicators (12) which indi-
cate the status of the charging process:
Red LED Status Green LED status Charger status
Off
Off
Off
On
On
Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charg-
er plug from the outlet and remove the battery from
the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Removing and mounting accessories (Fig. B)
Worn or damaged accessories must be
replaced immediately.
Only use sharp and undamaged accessories.
• Release the quick change lever (5) and slide the
accessory forward to remove from the holder.
• Slide the accessory in the holder and fasten the
quick change lever (5).
The sanding pad and the sanding paper must be
used for sanding applications.
4. OPERATION
Switching on and off (Fig. A)
• To switch on the machine, slide the on/off
switch (1) to the front.
• To switch off the machine, slide the on/off
switch (1) to the rear.
WWW.VONROC.COM
Setting the speed (Fig. A)
The speed adjustment wheel is used for setting the
speed. The speed adjustment wheel can be set to 6
positions. The ideal speed depends on the applica-
tion and on the material to be worked.
No power
Standby mode:
-
No battery is
• Turn the speed adjustment wheel (2) to the
inserted or,
required position.
-
Battery inserted
but charging has
Hints for optimum use
fi nished
• Clamp the workpiece. Use a clamping device for
Battery charging in
small workpieces.
progress
• Draw a line to defi ne the direction in which to
guide the accessory.
• Firmly hold the machine by the grip.
• Switch on the machine.
• Wait until the machine has reached full speed.
• Place the accessory on the workpiece.
• Slowly move the machine along the pre-drawn
line, fi rmly pressing the accessory against the
workpiece.
• Do not apply too much pressure on the machine.
Let the machine do the work.
• Switch off the machine and wait for the machine
to come to a complete standstill before putting
the machine down.
5. MAINTENANCE
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and dirt.
Remove very persistent dirt using a soft cloth mois-
tened with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
ENVIRONMENT
Do not set the speed during use.
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
EN
9
Publicidad
