Pop Up Message
Your Stimulator battery needs to be
replaced. Stimulation has been turned
OFF permanently.
Please contact your physician during
normal business hours.
Stimulation for one or more leads has
been turned OFF. Please contact your
physician during normal business
hours.
All stimulation has been turned OFF.
Please contact your physician during
normal business hours.
Stimulation has been turned OFF due to
a magnet. Please use your Programmer
to restore stimulation.
You have turned OFF all Stimulation.
Please use your Programmer to restore
stimulation.
Programmer battery is low.
Please recharge.
Spinal Modulation hereby declares that Axium Neurostimulators and Programmers are in compliance
with the essential requirements and other relevant provisions of Directive 1999/5/EC. The Declaration of
Conformity may be obtained upon request from the Manufacturer. Manufacturer contact information may
be found on the back cover of this manual.
Possible Solution
• Contact your doctor during normal business
hours to set up an appointment. Your battery
has reached End of Service (EOS) and will
not stimulate until it has been replaced.
• Move your Programmer over your Stimulator
to establish connection and reconnect to the
device.
• Go to the Pain Control screen and turn on
the lead that has been turned off.
• If it does not allow you to turn it back on,
contact your doctor during normal business
hours.
• Contact your doctor during normal business
hours.
• Move your Programmer over your Stimulator
to establish connection and reconnect to the
device.
• Go to the Pain Control screen and turn on
each lead one at a time.
You have turned off the device by pressing
the switch on the TNS or by pushing the
"Turn OFF All Stimulation" button on your
Programmer.
• Move your Programmer over your Stimulator
to establish connection and reconnect to the
device.
• Go to the Pain Control screen and turn on
the leads that have been turned off.
• The battery has reached 30% on your
Programmer and needs to be recharged.
21