Ricatech RR790 Manual De Usuario página 7

Press EQ / on the remote control to select the desired EQ mode.
The unit has 5 preset EQ modes:
RADIO
AM-FM Tuning
1. Press FUNCTION / to set the unit to TUNER mode.
2. Press STOP/BAND / repeatedly to select your desired waveband - FM or AM (= MW).
3. Auto Tuning – Press and hold FF/
or FB/ to scroll through the frequencies - the radio automatically tunes into a
station with good reception. If a station in received in Stereo, (ST) is shown. Repeat step 3 until you find the desired station.
4. Manual Tuning – Press FF/
or FB/ briefly and repeatedly until a station is found.
Programming Radio Stations
You can store up to a total of 40 radio stations (FM and AM) into memory, manually or automatically (Autostore)
1. Tune into your desired station
to activate programming, ― MEMORY‖ and P01 will start flashing on the display.
2. Press PROGRAM /
or PRESET – /
3. Press PRESET + / to allocate a number from 1 to 20 stations.
4. Press PROGRAM / to confirm, the display shows the preset waveband number and the frequency of the preset station.
5. Repeat steps 1-4 to store other stations into memory.
To listen to a Preset Station
or PRESET – /
Press PRESET + / once or repeatedly until the desired preset station in displayed.
Automatic Programming of Radio Stations
Automatic programming will start with preset 1, from this pre-set number onwards, former programmed Radio stations
will be erased.
button until ‗Auto' appears on the display.
1. Press and hold the PROGRAM /
―Memory‖ will start flashing on the display.
-