Jeep Hemlock Manual Del Usuario página 12

5. Assembly
Carefully remove the bike from the packaging* and remove the protective material taking care not to damage the relevant
aesthetic parts or force the cables and pre-assembled components.
*The bike must be removed from the packaging by two adults to ensure that it is not damaged and avoid the risk of injury
and/or crushing.
Handlebar installation
Rotate the fork until it is positioned in front of the frame, checking that the handlebar mount sits in front of and is aligned
with the frame, pending any subsequent adjustment required following installation of the handlebar and fitting of the front
wheel.
Remove the bolts securing the front clip at the end of the handlebar mount and insert the handlebar into the housing in the
central position.
Place the previously removed handlebar mount front clip in its original position and lightly and alternately tighten the
securing screws to adjust the correct positioning of the handlebar.
Complete the operation by tightening the screws.
11