Jeep Hemlock Manual Del Usuario página 13

Front wheel installation
HEMLOCK
Insert the front wheel into the appropriate fork housings (dropouts) and tighten using the appropriate quick release device
Lever Pin Locking nut
Conical springs*
(fig. A).
*Conical springs: position the end of the conical springs (those with the smallest diameter) in the direction of the wheel.
Insert the pin equipped with the relative conical spring inside the hub, leaving the lever on the right side of the cycle (side
without the brake disc); insert the second conical spring and the locking nut into the pin coming out of the hub on the
opposite side (side equipped with the brake disc), screwing it until it is flush against the dropout.
Close the lever towards the fork to complete the tightening operation by verifying that the lever has adequate resistance
during the closing phase (such as to leave a mark on the palm of the hand used to tighten the lever, so-called "imprint on
palm") and, after closing, requires a considerable force to be exerted to allow relative opening.
BLIZZARD
Insert the front wheel into the appropriate fork housings (dropouts) by securing and tightening the bolts (right and left side)
on the threaded hub pin as shown below.
12