Descargar Imprimir esta página

cecotec READY WARM 1200 THERMAL Manual De Instrucciones página 30

Ocultar thumbs Ver también para READY WARM 1200 THERMAL:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
ENGLISH
3. Select the desired operating mode by pressing the corresponding button: Day ,Sleep or
Anti-frost. The display will show the selected mode.
4. Use the + and – buttons to set the desired temperature for the selected mode. While the
temperature is being set, the "ºC" icon will blink.
5. Once the desired temperature has been set, the display will show the room temperature
again.
6. Repeat the before steps to set the temperature for the other modes.
7.
Use the on/off button to turn the heater on and off.
Thermostat
-
When the device reaches the set temperature, it will automatically switch off and the icon
will turn off.
-
When the room temperature falls below the set one, the device will automatically turn
back on and the icon will light up again.
Note
-
The power indicator may blink when the device is about to turn on or off.
-
The set temperatures will be saved even if the device is disconnected or turned off and on.
Reset
To reset the device while it is connected to the power supply and the power switch is on, make
sure the device is unlocked or unlock it with the remote control and press the power button (-)
for 3 seconds. It can also be switched off and on.
Scheduling mode
3 operating modes:
1.
Day mode: The temperature can be adjusted from 5 ºC to 35 ºC.
2. Sleep mode: The temperature can be adjusted from 5 ºC to 35 ºC.
3. Anti-frost mode: The temperature can be adjusted from 5 ºC to 15 ºC.
The temperature set manually will be applied to the modes during programmed operations.
Setting current day of the week and time
1.
Long press the "PROG" button until the display shows "00:00".
2. The hour digits will blink. Use the + and – buttons to set the desired hour and press "PROG"
to save the settings.
3. The minutes digits will blink. Use the + and – buttons to set the desired minutes and press
"PROG" to save the settings.
4. The display will show the week calendar (Monday-Sunday, 1-7). Select the current day by
pressing + and -. Press "PROG" to save the settings.
READY WARM 1200 THERMAL
30
READY WARM 1200 THERMAL BLACK

Publicidad

loading

Este manual también es adecuado para:

Ready warm1200 thermal black