cecotec READY WARM 1200 THERMAL Manual De Instrucciones página 31

Setting weekly schedule
1. The display will show the first 2 bars for the first period of time (00:00 – 1:00 am) blinking.
It will also show 1 as Monday.
2. Press the desired mode (Day, Sleep or Anti-frost) for the selected time interval.
- If you select Sleep mode, the display will show and the bar on the top part will blink.
- If you select the Anti-frost mode, the display will show and the bar on the lower part will
blink.
- If you select Day mode, the display will show and the top and lower bars will blink.
3. Once the first period has been scheduled, press "+" and the next time period's bars will
blink.
4. Repeat these steps up to 24 hours.
5. When all the hours in a day have been scheduled, press "PROG" to end the selected day
scheduling and repeat the steps to schedule the 7 days of the week.
6. Once the whole week has been scheduled, press "PROG" and the device will automatically
save the settings and operate in the set mode.
Warning
If the device is disconnected from the power supply, the schedule settings will be saved but the
current day and time will be reset.
Resetting the current time and day
1. To unblock the appliance, long-press "PROG" until the display shows "00:00". The hour
digits will flash, use the + and – buttons to select the desired hour, press "PROG" to switch
to minutes settings and use the + and – buttons again. Press "PROG" to save the settings.
2. Press "PROG" to save the settings.
3. The display will show the week calendar (Monday-Sunday, 1-7). Set the current day using
the + and – buttons and press the power switch twice. Then, press "PROG" and the + or –
button.
Adjusting temperature under programmed mode
1. During operation, press twice the on button on the remote control and use the + and –
buttons to select the desired temperature.
2. Once the temperature is set, it will be saved for this mode for future operations, including
under manual mode.
Note
If the appliance is operating under programmed mode, to change it:
1. Press the on button on the remote control twice.
2. Press "PROG".
3. Select the desired mode and adjust the temperature if necessary, using the + and –buttons.
READY WARM 1200 THERMAL
READY WARM 1200 THERMAL BLACK
ENGLISH
31