Remote Control - Ltc Audio ATM8000BT Manual De Uso

the recording and exit. If both USB flash drive and SD card are connected, the unit will begin recording onto the USB
flash drive. If the USB flash drive is full, remove it and then press the record button again to start another recording. The
unit will also be able to record the signal from microphone onto the USB flash drive or SD Card. When the recording
function is activated and there is a microphone connected and have it turned on, the unit will mix the signal from Tuner,
MP3 or DVD with the microphone's into one track. If two microphone are connected and turned on, both signals from
them will be recorded and mixed into one track with the signal from Tuner, MP3 or DVD.
THE RECORDING FILE FORMAT IS .WAV.
THERE IS NO RECORDING FUNCTION WHEN INPUT SELECTED IS USB/SD/BLUETOOTH.
Previous: Press this button to go back to the beginning of the current track or move to the previous track.
Next: Press this button to move to the next track.
Repeat/Random: Press this button to select the repeat mode between REPEAT ONE, REPEAT ALL, RANDOM. The default
setting is repeat all.
Input: Press this button to cycle through the various inputs.
USB: Connect your USB flash drive here
SD: Connect your SD card here
MP3 input: Connect your MP3 here
EQ MODE: Press this button to cycle through the pre-set equalizer modes.
Audio Function: Press this button to switch the control mode between bass, treble & master volume
MIC1 & MIC2: Connect your microphones here
MIC VOL: Use this knob to adjust the microphone volume
MIC ECHO: Use this knob to adjust the echo of microphone.
MIC Bass: Use this knob to adjust the bass of microphone
MIC Treble: Use this knob to adjust the treble of microphone
Headphone Output: Connect your headphone here
Sub Output: Use this knob to adjust the sub output volume
Pre Output: Use this knob to adjust the pre output volume
Master Volume: Use this knob to control the master volume

REMOTE CONTROL

MUTE: Mutes the sound output
: Play/pause button
: Stop button
INPUT: Press this button to cycle through the various inputs.
: Press this button to go back to the beginning of the current track or move to the
previous track
: Press this button to move to the next track
: Fast rewind
: Fast forward
TRE-/TRE+: Master Treble control
BAS-/BAS+: Master Bass control
VOL+/VOL-: Increase/reduce the volume
ENTER: Confirm the selection
EQ MODE: Press this button to cycle through the pre-set equalizer modes
REC: Press to start recording. Press again to stop recording
Number buttons: Direct selection of a track
10-/10+: To select a file number above 10. E.g. to select file no. 27, press twice 10+
©Copyright LOTRONIC 2018 ATM8000BT 3