Rear Panel; Remote Control - Ltc Audio ATM6100MP5-HDMI Manual De Uso

REAR PANEL

1. FM Antenna: Connect your FM antenna here
2. HDMI Output: Connect the monitor to this output via a HDMI cable.
3. Video RCA Outputs: Connect the monitor to these outputs via RCA cables. It's yellow, red and white cables.
4. AUX Input: Connect the AUX signal here
5. DVD Input: Connect the DVD signal here
6. Line Output: Connect this output to the AUX or DVD input of another amplifier
7. Main Speaker Outputs: Connect the speakers to these outputs.
Bluetooth Connection
To play Bluetooth signal, enable the Bluetooth function on a Bluetooth device like cell phone and set the
amplifier to Bluetooth input mode and then search for available Bluetooth devices nearby on cell phone. The
Bluetooth name of the amplifier is "ATM6100MP5-HDMI". Pair and connect. There is no pairing code.
Note: The amplifier is only discoverable when input is set to Bluetooth.

REMOTE CONTROL

1. Mute: Press this button to mute the volume output level
2. Mode: Press this button to switch among all the input modes
3. Power: Press this button power ON/OFF the function part of the unit
4. Photo: Press this button to start playing photos on USB flash drive or SD
card
5. Music: Press this button to start playing tracks on USB flash drive or SD card
6. Movie: Press this button to start playing videos on USB flash drive or SD
card
7. Play/Pause: Press this button to play the tracks or videos. Press again to
pause
8. Menu: Press this button to quickly go back to the main menu page
9. UP/DOWN/LEFT/RIGHT: Use these buttons to quickly go to a specific icon
and press "ENTER" to confirm
10. AUDIO: Press this button to confirm the audio playing
11. HDMI: Press this button to cut off the HDMI output.
©Copyright LOTRONIC 2016 ATM6100MP5-HDMI 4