Bluetooth Connection; Rear Panel - Ltc Audio ATM8000BT Manual De Uso

and then 7.
: Press this button to select the repeat mode between REPEAT ONE, REPEAT ALL
: RANDOM play button
AM/FM: Toggles between AM & FM radio reception
SCAN: Press to search for available radio stations
1 2 3 LED MODE buttons: No function
A/B: Press once to select speaker output A, press twice to select speaker output B, press a third time to select A & B
speaker outputs
OPERATION
Select a central location for the amplifier.
Connect the speaker wires (red & black) to the + and – terminals on the rear panel of the amplifier.
Connect the audio signal to the relevant sockets with the correct polarity.
Plug the mains lead in and switch the amplifier on once you have checked all connections.
Switch the audio sources on and adjust the master volume to the required level.
Karaoke: Plug a mic into MIC1 or MIC2 socket on the front panel. Before you use the mic, make sure that it is switched
off and the MIC volume button is set to the minimum. Connect the microphone, switch it on and adjust slowly the
volume and the echo.
If you don't use the unit any longer, switch the amplifier off and disconnect it from the mains.
Signal Sources and their Connections:
• Connect an audio source to the relevant input terminals or a data storage unit to the USB-interface or insert a
SD-memory card in the suitable slot or activate the Bluetooth function on your smartphone.
• Select the active signal source by pressing the INPUT button until the desired input source is displayed.
• Use the MP3 CONTROL-function for controlling the files on a connected data storage unit.
• If you wish to use the karaoke function of this device, insert one or two microphones into MIC1 and MIC2. Their
signals are going to the signal output too.

Bluetooth Connection

The ATM8000BT is only discoverable when the input selected is Bluetooth. After selecting Bluetooth input mode on the
ATM8000BT, turn on the Bluetooth function on the cell phone and search the ATM8000BT. Its Bluetooth device name is
"ATM8000BT". Pair and connect after search. There is no pairing code.

Rear Panel:

Power supply: Connect the unit to the power outlet.
Main Speakers Outputs: Connect your speakers here to receive the signal from the ATM8000BT
Surround Speaker Outputs: Connect your surround speakers here. Surround only works when all surround speakers are
connected.
Sub Outputs: Connect your subwoofer here.
©Copyright LOTRONIC 2018 ATM8000BT 4