Pleasant Hearth FA217S Instrucciones De Montaje página 4

ASSEMBLY INSTRUCTIONS
1a. Attach the two feet (B) to the front of the
screen (A) by inserting four 1/4" x 20 x 7/8"
Screw bolts (AA) through the pre-drilled holes
in the feet (B) and through the screen frame
(A). Secure with four 1/4" x 20 nuts (BB). Use
the allen wrench (DD) to hold the screw (AA)
in place while tightening the nut (BB) by hand.
Repeat for all 4 screws (AA)/nuts (BB).
Hardware Used
AA 1/4" x 20 x 7/8" Screw
BB 1/4" x 20 Nut
Allen Wrench
CC
2. Attach the back feet (C) to the back side of the
screen (A) by inserting one #8 x 32 x 3/4" (CC)
into the hole in each foot (C) as illustrated
in figure 2. Adjust feet (C) to desired width.
Tighten against the screen (A) using
the allen wrench (DD).
NOTE: The back feet are designed to adjust to
the inside width of your fireplace opening so
that, if desired, the screen can be placed flush
against the fireplace.
Hardware Used
CC #8 x 32 x 3/4" Screw
Allen Wrench
DD
1
BB
x 4
x 4
2
x 2
4
AA
B
A
C
A
CC