Deltaco Gaming WM80 Manual Del Usuario página 6

ENG
1. Left button
2. Right button
3. Mouse wheel and button
4. Forward button
5. Backward button
6. DPI button
7. LED mode button
Connect
Use the power switch to change between
modes.
2.4 GHz wireless mode: flip the switch to
the left and press and hold left, right,
and middle buttons for 3 seconds. The logo
LED confirms by flashing yellow. Connect the
USB receiver to a USB-A port on your com-
puter. The LED stops flashing to confirm. The
mouse will automatically connect to your
computer wirelessly. If you have connected
previously the mouse will remember the
connection.
Bluetooth mode: flip the switch to the right
and press and hold left, right, and middle
buttons for 3 seconds. The logo LED confirms
by flashing blue fast. You can now connect
with a device that supports Bluetooth, for
example your phone.
Wired (cable) mode: Wired mode is enabled
automatically if you connect a USB cable.
The mouse will charge and can be used at
the same time.
Notes on Bluetooth: the LED may flash
blue slowly indicating trouble with the
connection. If you have any trouble with
the connection, try to remove/forget the
connection on your device and make a new
connection. It might also help if you
restart your device.
Charge
To charge the mouse, connect it with a USB
cable to a computer. Charging: The LED is
red. Fully charged: the LED is green.
Power switch
On the underneath of the mouse there is
a power switch. You can change between 3
modes. Left, center or right.
6
Left = 2.4 GHz wireless mode.
Center = Power off.
Right = Bluetooth mode.
LED mode button
Press the LED mode button to cycle through
different LED modes. The last LED mode turns
off the LEDs.
DPI
Use the DPI button to change the
DPI. The default DPI settings are:
400/800/1600/2400/4800.
The corresponding colours are: red/green/
blue/purple/yellow.
Customize the DPI settings by using our
software.
When the DPI is changed in wireless mode,
the LED changes color to confirm the change.
When the DPI is changed in wired mode, the
LED flashes 3 times to confirm the change,
and then changes to show charge status.
USB polling rate
The default polling rate is set on 1000 Hz.
You can adjust the polling rate in 4 steps.
125/250/500/1000 Hz. 2.4Ghz wireless = 1000
Hz polling rate (recommended for gaming).
Bluetooth = 125 Hz polling rate. To change
the polling rate, use our software.
LED light
When you change DPI, there is a corre-
sponding LED that changes color. The LED
color for each DPI setting can be changed,
by using our software.
Cleaning
Clean the product by using a dry cloth.
Safety instructions
1. Keep the product dry. Keep it away from
all liquids.
2. Do not open up or try to repair the
product by yourself.
3. Keep the product and packaging out of